Starbucks gift card holder





This is a fun gift card holder with a starbucks front. The font is Babes in Toyland. There are two side flaps that get glued onto one another and then the bottom flap goes on top of those (to allow the gift card insert to insert and remove easily)

Files: SVG of the gift card holder
MTC file of the gift card holder



Comments

Post a Comment

Add your two cents.

Popular posts from this blog

Fall themed wedding favour bags and Josephine tassel

Image
These were quite fun to put together. As usual I didn't take a picture of the final project but what I really wanted to show you today is how to make the tassel. In order to make the tassel, you are going to start with 16 lengths of whatever string you are using. If you want a thicker tassel, use more lengths. Here I used kitchen twine. So the length of each piece of twine should be length of twine= (the length you want for the tassel)*2 + about 5" for the knot.  We are going to be following this knot type (it is called the Josephine knot): So here is what it looks like when you are doing it with a group of strings as opposed to just one. So to start you will split the pieces of twine into two piles (group A is the top one and group B is the bottom one): Then you will make a loop with group B: Then you will put group A under both parts of the loop of group B.  Then group A will go over top the right tail of group B. Then group A will go underneat...
Read more

A D&D birthday card

Image
 This card is kind of neat. I used the plastic part from a glue tape roll and put a dice in that. I glued it to a piece of cardstock and then put a black ring around it to give it a finished look. The concept of the dice is that my son rolls it and then looks up the dice roll on the list that is a pull out from the side. I think lots of us get many of these plastic bubbles from various goods. What I did is to scan the plastic bubble and then pixel traced it in Make-The-Cut (MTC). It will have an inner shape and the outer shape. The inner shape gets cut out of the middle of the card. The inner and outer shape get cut out of the contrasting colour. For the slide out part, I attached a piece of ribbon to the back of the pull out and then fed it through the left of the pocket. I did this because I didn't want the insert to come out all the way. The MTC file for the project is here:  https://www.dropbox.com/s/schkshtl5hz29an/Murdock_Birthday_share.mtc?dl=0 The SVG f...
Read more

Thanksgiving blessing bag

Image
We gave away bags filled with yummies at a Thanksgiving dinner we had at our church. I made these tags to go with them: We made 40 of the bags and 60 people showed up to share in the feast. And it was like the fish and the loaves. We expected 40/50 and enough food for 80 people showed up and we were able to feed another group the next day. SVG of the Canadian Thanksgiving tag MTC of the Canadian Thankgiving tag
Read more