Canuckian Crafting

What do you need: Masking tape (3/4") Piece of letter sized acetate (or letter sized glossy photo paper) Printer Check with the manufacturer to see which kind of acetate you can send through your printer The steps are fairly easy. If you are not a video watcher just follow these steps: Print one of the washi tape pdfs   Washi Tape1   Washi Tape2 Somehow tack it to the piece of acetate. You should be able to see the coloured strips through the acetate. Put the masking tape on the acetate on top of he coloured strips. Line it up as best you can. Remove the paper from the back of the acetate and remove the tacking tape. Cut the masking tape so that it doesn't go beyond the edges of the acetate. Burnish the top and bottom edges of the acetate so that the masking tape doesn't curl up. Run it through the printer so that the printer prints on top of the masking tape. Pull the masking tape off and roll it onto a clean straw (the thick ones from fast food plac

I found these flowers on thefrugalcrafter Lindsay Weirich's channel. Here is the video here:  https://www.youtube.com/watch?v=xg1x7rdkHY0 Here is my video. I used my cuttlebug to cut the circles just because I got a new die cut for it that does circles. The pack of 8 was around $2 USD from Aliexpress.com . So if I was going to do this video again, I would make the slits in the felt a whole lot shallower. and I probably wouldn't cut the felt to be such a wide strip. It would probably be fine being 2.75" wide (and then folded in two) and 11" (or 12") long. That would mean that you could get 3 per piece of felt. Here are the results: I am going to make the rose ones next. They will look so pretty together. Here is the video I am going to try for the rose felt: https://www.youtube.com/watch?v=MhIILNFsLr8